Building A Pair Of Heavy Duty Saw Horse
Posted by admin on February 13, 2010 under Glass Clamps Articles | 
Comments are off for this article
Start measuring and cutting all the fields cutting list and set it aside. Remove the legs and feel younger. The cone starts at 20 "from the ground. The leg tapers to 3-1/2" below. Repeat this step for all legs and cut.
The legs go in the main stretcher 75 °. This reduction is best viewed with a circular saw. Mark the rows, the stock clamp on the edge and cut. Turn to the field on the opposite side, and cut.
The time for a rally. OnThe main brand Stretcher line 1-1/2 "from each end. This is outside of the leg. now make a second label by a border of 1". This is the beginning of the leg. Do this for each leg on both stretchers.
Apply a little 'glue on the angled legs and the position of the marks you just made on the stretcher. Safe, with 4-2 "screws. Do this for all the legs.
Place 3 / 8 "offset brackets on the outside of the legs BUTTING the bottom of the main stretcher. ScribeAngle of the brackets with a pencil and cut. Po 'glue on the outside of the legs of the brackets and secure with 6 screws, three for each leg.
Now draw 2 lines below the length of each top-level offset 3 / 4 "in half. Countersink 5 Hole, 3 / 4" deep at every step. Alternating between the holes on each side of the center. Placing the tip on the stretcher snaps on the ends. Safe use of screws.
Finally, to ensure the lowest levels of the central leg with screws and glue.
This isThat's it. This horse is so easy to take the burden of a lift of plywood or studs. More like a box of large dimensions. Space of approximately 8 'each other and ensure a 2 x 10 between them.
Related posts:
- Mission Coffee Table Building
- How to build a good Picnic Table
- Ship-Building Tools
- Wood Craft Supplies For Beginners
- How to install recessed halogen lights